So DC fans seems to have very little voltage-to-rpm difference in the top, but a very steep voltage-to-rpm difference in the middle. If i set it to like 6, THEN they would go down to like 500-700rpm. If i lowered it to around 8, they would still be spinning around 1600-2000. If i had it on like 12v (full) they would spin around 2000rpm. There are 4 preinstalled RGB fans with propitiatory 6pin-cougar plugs, which all lead to a RGB hub connected to the ARGB header of the mobo (and also another SATA cable for PSU) These are standard DC fans that.I can't control their speed but at least my system should read their rpm. When i mixed around with my fans in the bios, i had to use DC mode to control them as they all were 3 pin. Another thing I realised is that DC fans are VERY hard to "control". I removed it and boom, both windows and the bios could read all the RPMs correctly. One of the fans can also be a bit broken, as I have encountered systems and bios reading RPMs wrong because of a single old fan that i had connected in my fan hub. Id like to link an exhaust fan the same way too to the second JRGB. Ive managed to link Hyper 212 RGB Black Edition cooler to it and i control it through MysticLight together with the cases led strip. ![]() I think "smart fans" just mean that you can set a fan curve and "Manual Fans" are just so you can set a constant speed. ProblemAttic said: Hi, My motherboard only has JRGB1/2 headers which are used to control 12 RGB LED strips. Is there anything I am missing here? Should I make any specific change to settings? Thanks in advance, any help would be greatly appreciated!!! In BIOS the picture is the same, the only fan the system reads is from CPU! Also there is another hub for RGB, which is connected to the second ARGB header of the mobo. Thing is, my system can't read the rpm of these fans either, yet they are PWM! Here is a screenshot from Dragon Center. Anyway, they are DC so I just moved on and bought DeepCool MF120GT 3 fan pack because I needed some better cooling (which I actually made-more info on upcoming post) and ofc the RGB (excellent design for exhaust fans) These fans are actually PWM, they lead to a 4-pin PWM hub connected to the SYSFAN1 header of the mobo. There are 4 preinstalled RGB fans with propitiatory 6pin-cougar plugs, which all lead to a RGB hub connected to the ARGB header of the mobo (and also another SATA cable for PSU) These are standard DC fans that.I can't control their speed but at least my system should read their rpm.amiright? Many people say even on DC fans, rpm can be controlled. Hello! I recently built my new rig, in which I selected for case a Cougar MX410-G Mesh RGB.
0 Comments
Leave a Reply. |